To check the initial priority value, we can use the ‘show lacp sys-id’ command. Switch1#show lacp sys-id 32768, 5254.0003.8000. We’ll configure Switch1 to have a system priority of 1. Therefore, it will become the master switch. SW1 (config)# lacp system-priority 1 Switch1#show lacp sys-id 1, 5254.0003.8000.
Use lacp period short to set the shortLACP timeout interval (3 seconds) on an interface. Use undo lacpperiod to restore the default. Syntax. lacp period short. undo lacpperiod. Default. The LACP timeout interval is the long timeout interval (90 seconds) on an interface. Views. Layer 2 Ethernet interface view. Predefined user roles. network ...
I have a LACP team setup through windows with dynamic load balancing. It works fine until I reboot the server. The server comes back up with the team adapter missing from network connections and both of the 10G NICs in a " faulted not found" state. I can reactivate by disabling and re-enabling each of the NICs .
When Nexus-1 sends out LACP PDU eth1/1 for first time, it will have it's Actor information (System, System Priority , Port , Key, Port - Priority , State) & default Partner information.
Introduction. This chapter defines Link Aggregation Control Protocol (LACP), introduces related concepts, and provides configuration examples. LACP is a basic feature of Huawei data communications products, including switches, routers, WLAN products, and firewalls. Descriptions and examples in this chapter are based on Huawei's S12700 switch.